 |
 |
 |
 |
|
 |
|
Description
- Place edge mold in your form
and either silicone in place, nail with a small finish nailer, or screw
through the backing form into the form.
- For most applications, run a
silicone a bead across the bottom edge of the form, and up any corners,
and across any joined together seams, to create a tight seal.
- Use of a rubber safe form
release, pol-ease 2300 is recommended, but not necessary. Form release
generally will create a smoother finish on the concrete, less air pockets
in the concrete edge, and easier to clean the edge mold when finished.
|
|
|
|
|
|
|